80pctlower
Lowers that are nearly complete.
80 percent Lower
80% lower No FFL required, these are not lower receivers but are mearly incomplete until the following are completed.

Made of 7075 T6 forged Aluminium, same as normal completed lower receivers.

Pulled from final completion for sale as 80 percent lower receiver (non finished).  These are made the same as normal lower receivers but require finishing to be classified as a firearm.

Lowers that are nearly complete and only require

1.  Milling out of the receiver interior

2.  Cutting of the trigger slot

3.  Drilling of the trigger pin hole

4.  Drilling of the hammer pin hole

 

Completed areas:

Buffer tube area complete and threaded, detent pin holes drilled for both front pivot pin and rear takedown pin.

Magwell completely finished.  Pistol grip area finished with selector detent pin hole drilled, and threaded pistol grip screw hole.

Mag Catch and bolt catch area finished.  Selector hole finished with markings.  Trigger guard holes finished.

!

80 % pct AR-15
+Shipping charges
!
80 % pct lower receiver for AR-15 type rifles.

80 % pct lower receiver.

Lowers that are nearly complete and only require

1.  Milling out of the receiver interior

2.  Cutting of the trigger slot

3.  Drilling of the trigger pin hole

4.  Drilling of the hammer pin hole.

 

Completed areas:

Buffer tube area complete and threaded, detent pin holes drilled for both front pivot pin and rear takedown pin.

Magwell completely finished.  Pistol grip area finished with selector detent pin hole drilled, and threaded pistol grip screw hole.

Mag Catch and bolt catch area finished.  Selector hole finished with markings.  Trigger guard holes finished.

 

.308 7.62 X 51 AR-10 80 percent not a complete Lower Receiver
+Shipping charges
!
308ltsidefull80pct
.308 left side full view. 
.308 7.62 X 51 AR-10 type 80 percent lower receiver.  These are made for the DPMS style AR-10.

Lowers that are nearly complete and only require

1.  Milling out of the receiver interior

2.  Cutting of the trigger slot

3.  Drilling of the trigger pin hole

4.  Drilling of the hammer pin hole

everything that is finished is to specification. Buffer tube area is threaded.

** includes 2 set screws and pins for bolt catch pivot and rear takedown pin detent.